Note also that in §1926.1053(a)(13), the shortest clear distance permitted behind a fixed ladder is 7 inches (except for an elevator pit ladder, in which case it is 4.5 inches). Ģ Seven inches of clearance is agenerally recognized minimum see, for example, the American National Standards Institute standard A14.3-2002, section 5.4.2.1, which calls for 7 inches of clearance behind ladders. You can also contact us by mail at the above office, Room N3468, 200 Constitution Avenue, NW, Washington, DC 20210 although, there will be a delay in our receiving correspondence by mail.ġ This section incorporates Part 1926 Subpart X by reference in the case of portable ladders. Department of Labor - OSHA, Directorate of Construction, Office of Construction Standards and Guidance 20. If you need any further clarification on this subject, please contact us by fax at: U.S. However, under the "General Duty Clause" (Section 5(a)(1)) of the Occupational Safety and Health Act, employers must "furnish to each of employees ee from recognized hazards that are causing or are likely to cause death or serious physical harm." It is recognized in the industry that there must be sufficient toe-hold clearance on ladder steps to enable the workers to safely use the rungs. The scaffold standard is silent about toe-hold clearance distances for attachable ladders used on supported scaffolds. Question 2: Is there a toe-hold minimum distance requirement for attachable ladders used on supported scaffolds? There is no requirement in the standard that workers use fall protection while climbing up or down these ladders. (vi) Hook-on and attachable ladders shall have uniformly spaced rungs with a maximum spacing between rungs of 16 3/4 inches.Īs you can see from §1926.451(e)(2)(iii), when attachable ladders are used on supported scaffolds more than 35 feet high, they must have rest platforms at no more than 35-foot intervals. (v) Hook-on and attachable ladders shall have a minimum rung length of 11 1/2 inches (29 cm) and (iv) Hook-on and attachable ladders shall be specifically designed for use with the type of scaffold used (iii) When hook-on and attachable ladders are used on a supported scaffold more than 35 feet (10.7 m) high, they shall have rest platforms at 35-foot (10.7 m) maximum vertical intervals. (ii) Hook-on and attachable ladders shall be positioned so that their bottom rung is not more than 24 inches (61 cm) above the scaffold supporting level In 29 CFR Part 1926 Subpart L (Scaffolds), §1926.451(e)(2) details the requirements for use of "portable, hook-on and attachable ladders." 1 Section 1926.451(e)(2) requires that: (i) Portable, hook-on and attachable ladders shall be positioned so as not to tip the scaffold Question (1): What OSHA construction scaffold requirements apply to attachable (bolt-on) scaffold ladders? Is fall protection required for workers as they climb up or down these ladders? We have paraphrased your questions as follows: We apologize for the delay in responding. You ask about requirements in the construction scaffold standard. This is in response to your letter postmarked January 4, 2003, to the Occupational Safety and Health Administration (OSHA). 1 All of these can be controlled by compliance with OSHA standards.Re: OSHA requirements for attachable scaffold ladders used in construction - §1926.451(e) fall protection toe-hold clearance. The Bureau of Labor Statistics' Census of Fatal Occupational Injuries (CFOI) reported 52 fatal falls to lower levels from scaffolding in 2020. Replaces traditional shipyard scaffolding. Provides general requirements for all scaffolds AND also includes information on specific types of scaffolding. OSHA has targeted the industry in its Strategic Plan to reduce injuries and illnesses and prevent fatalities. Spring-loaded locking latch makes it easier and quicker to install/remove than any other stabilizer on the market. Shipyard work has traditionally been hazardous, with an injury-accident rate more than twice that of construction and general industry. Plastic Ladders scaffolding Step ladders RELATED PRODUCTS 213 Werner Aluminum AC78 Stabilizer for Ladders AC78 Quick Click stabilizer spans 44 In. Helps workers identify and control the hazards that cause the most serious scaffold-related injuries. Contains information that helps workers identify and control the hazards that cause the most serious construction-related injuries. Hazards are identified, as well as the controls that keep these hazards from becoming tragedies. Provides illustrated safety checklists for specific types of scaffolds. OSHA Fact Sheet (Publication 3722), (April 2014). OSHA Fact Sheet (Publication 3759), (November 2014). Tube and Coupler Scaffolds - Erection and Use.OSHA Fact Sheet (Publication 3760), (November 2014). Tube and Coupler Scaffolds - Planning and Design.Ladder Jack Scaffolds - Supported Scaffolds.OSHA Hazard Alert (Publication 3842), (2016).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |